How many Double Roman roof tiles do I need? Tiles per m², pallets and fittings

How many Double Roman roof tiles do I need? Tiles per m², pallets and fittings

Double Roman roof tiles per m²

How many Double Roman roof tiles do I need? Tiles per m², pallets and fittings

Allow 10.6 West End Double Roman roof tiles per m² of sloping
roof
for both Classic Standard and X-Treme Standard. A 100 m²
sloping roof takes 1,060 main tiles before cuts. If
your roofer allows 5% extra, order for 1,113 main
tiles
, then add the fittings that your roof shape requires.

Which measurement
goes into the calculation?

Look at the wording on your drawing. Two sloping roof faces of 50 m²
each give you 100 m² to tile. A 100 m² floor plan tells you something
different. The roof may extend beyond the walls, and the pitch increases
the surface area.

If you have the horizontal roof area including the eaves, enter that
figure and the pitch into the Gauteng
roof tile estimator
. It converts the plan area to slope area and
includes 5% extra. If your roofer has already measured the slopes, use
those measurements directly in the table below. Applying the pitch
adjustment twice will inflate your order.

How many tiles do
I need for 50, 100 or 150 m²?

Sloping roof area Main tiles before cuts Main tiles with 5% extra
50 m² 530 557
100 m² 1,060 1,113
150 m² 1,590 1,670

Multiply the slope area by 10.6, apply your roofer’s allowance, then
round up to a whole tile. The table uses 5% as a planning example. A
roof with several hips or valleys may need a different allowance from a
simple gable roof.

How much does a pallet cover?

A pallet holds 240 main tiles, enough for
approximately 22.6 m² before cuts. For the 100 m²
example above, four pallets give you 960 tiles. You need another
153 tiles to reach 1,113. Five full pallets would give
you 1,200, or 87 more than the estimate. Ask whether the supplier can
quote the exact quantity and how a part load affects delivery.

How many
ridge tiles and verge fittings should I add?

Use the length of each individual run and the fitting specified on
your roof plan. Count each run separately and round up. For four
separate hips, allow four hip starters and ask your roofer for the
fittings needed along the remaining length of each hip.

West End fitting Estimating rate Units per full pallet
Taper ridge 2.7 per metre 160
Mono ridge 2.7 per metre 60
V-ridge 2.2 per metre 160
Rake verge 3.5 per metre 225
Hip starter 1 per hip 80

For example, a roofer specifying taper ridges for a 12 m ridge needs
12 × 2.7 = 32.4, rounded up to 33 taper ridges before
spares. Two separate 5 m rake verges each take 18 fittings, or
36 rake verges in total. See the roof
fitting illustrations
if you need to identify the pieces on your
schedule.

What should I send for a
quote?

Send the roof plan, the chosen profile and your Gauteng delivery
suburb. If you already have a tile count, state whether it includes cuts
and spare tiles. Use our guide
to comparing delivered roof tile quotes
to check that suppliers
price the same quantities, or upload your
plans for an itemised quote
.

Get a Quote

Product Search